Cornelius P/N 620032802, P/N 629085001 installation instructions Icemaker Adapter KIT P/N

Cornelius Incorporated

500 Regency Drive

Glendale Heights, IL 60139

Telephone (630) 980-6900

Facsimile (630) 980-8511

ICEMAKER ADAPTER KIT (P/N 629085001)

This Icemaker Adapter Kit (P/N 629085001) is for the following Units:

Dispenser Model		Icemaker Model
ED200/250		Wilshire WCC500/700
		Table 1. Adapter Kit Parts
Item
No.	Part No.	Name	Qty.
1	620032802	Icemaker Adapter Lid	1
2	22128	Bracket, Icemaker Mounting	2
3	50904	RTV, 3-Oz. Tube	1
4	620032804	Cover, Manual Ice Fill	1
5	70226	#10 Sheet Metal Screw	12
6	70188	Thumb Screw, #8--32X3/8--in. Long	1
7	620913501	Installation Instructions	1

CAUTION: Disconnect electrical power from the Dispenser before attempting to install this Kit.

1.Remove merchandiser from the Dispenser by lifting up on both the right and the left sides to disengage the merchandiser from slots in the Dispenser cabinet. Tilt the merchandiser forward from the top and lift off.

NOTE: Disregard step 2 if the ice diverter has been factory installed.

2.Refer to Figure 4 for the following:

A.Remove the ice chute cover (snap-fit) and ice chute (4 nuts).

B.Remove the gate restrictor and discard.

C.Install the ice diverter as shown.

D.Replace the ice chute and cover.

3.Refer to Figure 3 for adjusting the automatic agitation timer.

A.Loosen/rotate the center mounting screw that secures the white reflector panel/electrical control box cover in place and lower the cover to expose the automatic agitation timer.

B.Adjust the timer to 2-seconds “ON”and 1-hour “OFF”as shown in Figure 3.

C.Reinstall the white reflector panel and the merchandiser.

E IMI Cornelius Inc; 1998	REV: A	October 27, 1998
		620913501