Continuous Flow Icemaker Service Manual
MOTOR CHECK
The resistance readings on the winding will be between 5 to 25 ohms. A meter capable of these low readings must be used. The start relay cover must be removed.
If no continuity on start or run winding test, replace gearmotor. If continuity on grounded motor test, replace gearmotor.
START RELAY
1.Check between “2” and “4” on relay (with relay unplugged). If there is continuity replace the relay, as the relay contacts should be open.
2.Check between “3” and “4” on relay, if no continuity replace the relay.
FIGURE 7. GEARMOTOR ASSEMBLY
TO REPLACE GEARMOTOR ASSEMBLY
1.Disconnect the icemaker from the electrical power source.
2.Disconnect the transmission cable from the electrical box.
3.Remove the 4 hex head bolts securing the evaporator to the top of the transmission.
4.Remove the 4 bolt’s holding the transmission and bracket to frame base, while supporting the weight of the evaporator. Remove the transmission from the unit.
5.When replacing the transmission, it may be necessary to rotate the auger back and forth to align the motor shaft and auger.
AUGER NUT | AUGER |
|
BEARING NYLON
BEARING DELRIN
“D” DRIVE
GROOVE
EXTRUDING
HEAD
RIB – 3 PLACES
FIGURE 8. AUGER AND EXTRUDING HEAD REMOVAL
© | - 13 - | Publication Number: 630460324SER |
