INSTALLINGYOUR TELEPHONE
DESKINSTALLATION
To install a desk telephone, use the long modular line
cord supplied with your telephone. Plug one end of the linecordintotheconnectoronthebackofyourtelephone and the opposite end into the modular wall jack. Your telephone is ready to use.
To disconnect your telephone, press the spring clip on the line cord plug and pull out.
WALLINSTALLATION
To install a modular wall telephone, refer to the diagram to the right.
•Fit the plug (1) on the back of the telephone into the jack (2).
•Align slotted holes (3) on the back of the telephone over the
mounting studs (4).
•Gently pull down on the telephone until it locks in place.
NUMBERCARD
PUSH-BUTTONDIALTELEPHONES
Writeortypecorrecttelephonenumberon number card and fit into number card slot in the telephone faceplate. Insert one end of the clear plastic retainer in one end of theslotand,holdingtheretainerasshown at right, bend the opposite end down into the slot and let it snap into place. To
removetheretainer,insertastraightenedpaperclipintothesmall slot in the retainer and pry outward.
ROTARYDIALTELEPHONES
Rotate the finger wheel clockwise as far as it will go and hold inthispositiongently.Insertthestraightenedendofapaperclip or similar tool into the pin hole of finger wheel which is now about 1/4 inch to the left of the finger stop. Press down firmly on the paper clip and rotate the finger wheel further clock- wise until paper clip is aligned with the "9" position on the number dial. Now lift finger wheel from dial.
