Instruction Manual: COSTAR® 9SS, 9V CO Safety Shutoff
Once the unit is installed and operating, the red L.E.D. will flash once every
LOW-BATTERY WARNING:
When the battery becomes weak, the red L.E.D. will flash, and sound a “beep” once every
FAULT CONDITION:
Periodically, the unit measurement circuit is
APPLIANCE SHUT DOWN:
If the unit measures an unsafe level of CO, it will shut down the appliance.
IF COSS IS ACTIVATED:
1.Get fresh air into the premises immediately.
2.Call a qualified technician to inspect the appliance and venting systems and adjust, repair or replace as necessary. NOTE: The appliance cannot be restarted until CO dissipates and the danger is eliminated.
REPLACING THE BATTERY:
1.Remove the plastic cover of the CO Safety Shutoff from the base.
2.Remove the battery and replace it with the new one. (Figure 2)
3.
4.Test CO Safety Shutoff for proper operation as described above by pushing test button. Repeat weekly. Use on the following
Eveready 522; Duracell MN 1604; Gold Peak 1604A
TO CLEAN:
Use a vacuum cleaner to remove dust
OPERATING TEMPERATURE RANGE: 32° F to 125° F
SERVICE AND WARRANTY
If, after reviewing this manual, you feel that your CO detector is defective in any way, do not tamper with the unit. Contact the manufacturer, Quantum Group Inc., to receive a return material authorization number (RMA). Once the RMA number is given, you should return the product with the RMA number on the outside of the packaging to:
7737 Kenamar Court
San Diego, CA
Or call us toll free
QGI P/N