(2)Acorn nuts (located on the machine, remove before installing the Wheel Frame Assembly) 13mm/16mm wrench
Operating Handle w/knob 10mm/12mm wrench Metal Shears (Side Cutters) Eye Protection
Extra hydraulic seal
WARNING! Wear eye protection when cutting the banding. The banding is under high tension and may snap and strike you when cut. Stand to one side when cutting the banding.
1.Cut the banding around the shipping box and open the box.
2.With the help of another person (the machine weighs 105 pounds), carefully remove your new DR 4
3.If you have banding around your motor and frame as shown in Figure 2, cut the banding. Be careful when cutting the banding.
4.Remove the wooden packing wedge between the motor and the housing.
Note: Look under the machine, the wedge may be difficult to see.
5.Remove any remaining packing materials from the wood splitter. Do not discard your packaging material until you are fully satisfied with your new DR 4
WOOD SPLITTER.
6.Attach the Wheel Frame Assembly to the main frame using the two Acorn nuts and the 16mm wrench (Figure 2).
7.Screw the Operating Handle clockwise onto the shaft protruding from the Support Plate and tighten it securely using the 10mm wrench (Figure 3).
Band
Acorn
Nuts
Wheel Frame
Assembly
Figure 2
Support Plate
OperatingHandle
Turn in
Clockwise
Figure 3
10 | DR 4 |