Coustic owner manual XM6 Controls & Indicators, Equalization point between 40Hz 100Hz

12

11

13

15

21

19

21

WWW.COUSTIC.COM

XM6: CONTROLS & INDICATORS

11	Parallel Input Switches – “IN”: Each appropriate switch must be set
	to the “IN” position when the source unit does not supply rear or
	subwoofer channel outputs. “OUT”: If the source unit has independent
	front, rear and/or sub channel outputs, set each switch to the “OUT”
	position
12	High-Pass Frequency Selectors – For selection of high-pass crossover
	frequency between 40Hz and 400Hz, 18dB/Octave
13	Frequency Multiplier – To change selected high-pass crossover
	frequencies from 40Hz - 400Hz, to 800Hz - 8000Hz, 18dB/Octave
14	Band Pass Switch – Positioning this switch to the “IN” position reconfig-
	ures the “B” channel from a high pass output to a band pass output.
	When the “IN” position is selected, the band pass frequency selector is
	engaged.
15	Band Pass Frequency Selector – For selection of the top crossover point
	of the band-pass frequency range between 300Hz and 3kHz,
	18dB/Octave. (The high pass frequency selector must be used to
	select the bottom crossover point for the band-pass frequency range.)
	The full band pass frequency range is 40Hz to 3kHz, 18dB/Octave.
16	Subwoofer Frequency Selector – For selection of the low-pass crossover
	frequency between 40Hz and 200Hz, 36dB/Octave
17	Bass Shaper Frequency Selector – For selection of low frequency
	equalization point between 40Hz - 100Hz.

12

14

11

19

18	Bass Shaper Boost Level Control – For adjusting the Bass Shapers
	selected equalization frequency level with a maximum boost of 18dB
19	Phase Control Switch – Positioning the switch to the “180”
	position shifts the right output signals on channels “A” and/or “B”

23	20
16		22
17	18

XM6 CONTROL PANEL

	180 degrees out of phase relative to their left output signals
20	Sub Phase Control Switch – Positioning the switch to the “180”
	position shifts the subwoofer output signals 180 degrees out of phase
	relative to channels “A” and “B” output signals
21	Independent Output Level Controls – Independent left and right output
	signal level adjustments can be made for accurate stereo balance and
	imaging
22	Subwoofer Output Level Control – For adjusting the low pass output
	signal level
23	Power Indicator – This indicator lights up when the internal switching
	power supply is activated and the unit is operational

9