WARNING: Always wear safety eyewear complying with ANSI Z87.1 (or in Canada CSA Z94.3) when using as a blower.
_1_WARNING: To avoid injury to bystanders, keep them clear of blowing debris.
ACAUTION: Wear a dust mask if
blowing creates dust which might be inhaled.
_, CAUTION: To reduce the risk of hearing damage, wear ear protec- tors when using the Vac/blower for extended hours or when using it in a noisy area.
2.Insert the locking end of the
assembly and pull the hose out of the Vac inlet.
3.(Optional) Attach extension wand to
opposite end of hose.
4.Turn Vac on and you are ready to use your Vac as a blower.
Craftsman recommended accessories are available at Sears retail stores and sears.com. The Sears Car Nozzle Stock No. 17839 is recommended for blowing debris.
Locking
g Port
Hose End
Extension
_nd
•Car Nozzle
Maintenance
Filter
WARNING: To reduce the risk of
injury from accidental starting, unplug power cord before changing or cleaning filter.
NOTE: This filter is made of high quality paper designed to stop very small parti- cles of dust. The filter can be used for wet or dry pick up. Handle the filter carefully when removing to clean or installing it. Creases in the filter pleats may occur from installation but creases will not affect the performance of the filter.
Filter Cleaning
Your filter should be cleaned often to maintain peak Vac performance.
Be sure to dry the filter before storing or picking up dry debris.
IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small hole can cause a lot of dust to come out of your Vac. Replace it immediately.
Filter Removal
To remove the filter for cleaning or replacement, unscrew the filter nut from the filter cage, remove filter plate and lift off filter.
IMPORTANT: To reduce the risk of damage to the blower wheel and motor, always reinstall the filter before using the Vac for dry material pickup.
Cleaning A Dry Filter
10
