Craftsman 113.2472T0 owner manual Mounting the Front Table, Lad E

6.To insure the backup bearing is properly sup- porting the blade, push the bearing toward the blade until it almost touches it. Turn the upper

wheel, by hand, checking the backup bearing to make sure it is not turning. If the bearing is

turning the blade is too close. Move bearing slightly away from blade and tighten set screw with 1/8" hex "L" wrench. Turn upper wheel and recheck the bearing. Adjust again if necessary.

7.Repeat procedure for lower backup bearing.

8.Turn upper wheel by hand and check the blade guides and backup bearings to make sure they are adjusted correctly. Make any readjustments if necessary.

9.Install blade guard and tighten with phillips screwdriver. (See illustration, page 19.)

10.Install the front cover. Rest top edge of cover on two latch springs along the top edge of back cover. Swing cover down into position, engaging the three other latch springs. Push the front cover into position on the back cover. Check that the lip on the front cover completely overlaps the lip on the rear cover.

MOUNTING THE FRONT TABLE

1. Turn front table over. Locate the two (2) latch springs, two (2) alignment springs, and the four

(4)1/4-20 x 5/8 hex washer head thread forming screws.

2:Install the two latch springs on the front table as illustrated using a 3/8-inch wrench or socket.

Install the two alignment springs on the front table as illustrated using a 3/8-inch wrench or socket.

3.Locate the two (2) oval point setscrews 1/4-20 x 1/2 and use an 1/8-inch hex "L" wrench to install

in the two holes, as illustrated, but do not allow the screws to extend beyond the underside of the table.

	'4''"'--"	B LAD E	I	I
z i	F	BACKUP BEARIING		I

"1

"1

z

J

I

FRONT COVER

SPRING

_114-20 x 5/8

_"*-."_--- WASHER HEAD

SCREW

...-.L =i_-_'''''_ALIGNMENT

"'_T	_'_..._			SPRING
	',	I	_	LATCH SPRING

,../HEX"L"WRENCH

j.l/4-20X1/2

I _ OVAL pOINT

ySETSCREW

FRONT TABLE

22