![](/images/new-backgrounds/1209508/20950833x1.webp)
NOTE: Mounting hardware is not included with this tool. Bolts, nuts, washers, and screws must be purchased separately.
2.For portable use, place the saw on a 3/4 in. thick piece of plywood. Bolt the base of the miter saw securely to the plywood using the mounting holes on the base. Use
Fig. Q
●Laser Warning Label:
Max output <1mW DIODE LASER:
630-670nm, Complies with 21CFR 1040.10 and 1040. 11.
3/4 Inch Plywood
Hand Hold for
Transportation
THE LASER GUIDE (FIG. R)
1.To turn laser on, turn switch (1) to “I” position.
2.To turn laser off, turn switch to “O” position.
Fig. R
1
Your tool is equipped with the Laser Guide using a Class III laser beam. The laser beam will enable you to preview the saw blade path on the stock to be cut before starting the miter saw. This laser guide is powered by two AAA 1.5 volt batteries.
AVOID DIRECT EYE CONTACT
! WARNING
●Laser is radiated when laser guide is turned on. Avoid direct eye contact. Always
! WARNING
●Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
! WARNING
●The use of optical instruments with this product will increase eye hazard.
●Do not attempt to repair or disassemble the laser. If unqualified persons attempt to repair this laser product, serious injury may result. Any repair required on this laser product should be performed by a Sears or other qualified service center.
NOTE: All the adjustments for the operation of this machine have been completed at the factory.
17