Craftsman 137.248830 operating instructions Full ONE Year Warranty, Motor, Saw, 5000, Yes

SECTION	PAGE	SECTION		PAGE
Warranty	2	Know Your Table	Saw	8
Product Specifications	2	Assembly and Adjustments		9
Power Tool Safety	3	Operation		16
Table Saw Safety	4	Maintenance		20
Electrical Requirements and Safety	5	Troubleshooting	Guide	21
Accessories and Attachments	6	Parts List		22
Tools Needed For Assembly	6	Push Stick Pattern		30
Carton Contents	6

FULL ONE YEAR WARRANTY

If this product fails due to a defect in material or workmanship within one year from the date of purchase, Sears will at its option repair or replace it free of charge.

Contact a Sears Service Centre for replacement.

If this product is used for commercial or rental purposes, this warranty applies only for 90 days from the date of purchase.

This warranty is in addition to any statutory warranty.

Sears, Roebuck & Co., Dept. 817 WA, Hoffman Estates, IL 60179

[A WARNING I

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

•Lead from lead-based paints

•Crystalline silica from bricks, cement and other masonry products

•Arsenic and chromium from chemically treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your

exposure to these chemicals work in a well-ventilated area and work with approved safety equipmentsuch as dust masks that are spec a y des gned to f ter out m croscop c part c es.

MOTOR		SAW
HP (Maximum developed)	3.0	Table Size	........................	26-7/64" x 19-1/2"
Type	Universal	Table Extensions		3 - Left,Right,Rear
Amps	15	Extension	Rip Capacity	24" Right and Left
Voltage	120	Blade Size	........................	10" Diameter
Hz	60	Arbor Size	........................	5/8" Diameter
RPM (no load)	5000	Rip Fence	........................	Self Aligning
Overload Protection	YES	Miter Gauge		T-Slotted
		Maximum	Cut Depth @ 90%	3"
		Maximum	Cut Depth @ 45°..	2-1/2"
		Maximum	Dado Cut Width...	1/2"
[A WARNING I		Net Weight	......................	65 LBS

To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.

This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in any way.

Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow these rules could result in serious injury to you or damage to the table saw.