Craftsman 139.53675SRT owner manual Proceed to, Pivot hardware

Pead the Safety instructions on page 12. They also apply to doors withm_t tracks.

Header Wall

•Close the door and mark the inside ve_c_t centedine of

your garage door. Extend the fine onto the header wall above door.

If headroom clearance is minimal, you can install the header bracket on the ceiling° See page 14.

•If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws

(not supplied) to securely fasten the 2x4 to structural

supports as shown.

Header WalJ

/

Highest Point

of Travel

Jambii

Haxdware

One-piece door without track jamb hardware

°Open your door to the highest point of travel as shown. Measure the distance from the top of the door to the floor. Subtract the actual height of the door. Add 8" to the remainder. (See Example),

•Close the door and draw an intersecting horizontal line on the header wall at the determined height.

If the total number of inches exceeds the height available in your garage, use the maximum

height possible, or refer to page 14 for ceiling installation.

2x4

One-piece door without track

pivot hardware

	EXAMPLE
Distance from top of door
(at highest point of travel)		to floor	............................ 92"
Actual	height of door		-88"
Remainder			4"
Add			+8"
Bracket	height on header	wall	=12"

(Measure UP from top of CLOSED door)

Proceed to Step 2, page 14.

13