Craftsman 139.53675SRT To reduce the risk of severe, Injury or death to persons, Maintenance

		ii	_L,	I ii
IMPORTANT SAFETY INSTRUCTIONS
i........ i_	i	_,?.	iiiiii

To reduce the risk of severe

1.READ AND FOLLOW ALL INSTRUCTIONS.

2.Do not permit children either to operate or to

play with the opener. Keep remote control in a tocation inaccessible to children.

3.Operate opener only when the door is in full view and free from any obstruction. Keep the door in sight until It Is completely closed. NO

ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.

4.Check safety reversal system monthly. See page 30. The gauge door MUSTreverse on contact with a one-inch (or a 2x4 board laid flat) object placed on the floor. If an adjusb'nent is made to either the force or the limit of travel, both adjustments may be needed and the safety reversal system must be checked.

Failure to properly adjust the opener may

result in severe injury or death.

,,,,,, ,,,,, •

injury or death to persons:

5.If possible, use the emergency release only

when the door is in a closed position. Caution should be t_ken whenever the disconnect cord

is actuated wIth the door open. Weak or broken springs may cause the door to fall rapidly, causing injury or death to persons.

6.KEEP GARAGE DOORS PROPERLY BALANCED. See page 3. An improperly balanced door may not reverse when required and could result in severe injury or death. Repairs to cables, spring assemblies and other hardware must be made by a professional garage door person.

7.Disconnect the electric power to the garage door opener before making any repairs or removing the covers.

8.SAVE THESE INSTRUCTIONS.

II

Care of Your Opener

Limit and force adjustment controls

Limit Controls Force Controls

A_ustmen= L_bel_ent Label

(Lor_led on the left side pBneI) (Located on the right side pane_)

Weather conditions may cause some minor

changes in door operation requiring some re- adjustments, particularly during the first year of operation.

Pages 28 and 29 refer to the limit and force adjustments. Only a screwdriver is required. Follow the instructions carefully.

Repeat the safety reverse test (page 30) after any adjustment of limits or force.

The remote	control	3-FUNCTION
The lithium	batteries should	Open this end _..,
produce power for up to
5 years. To replace batteries,		hc_s_ny
use the visor clip or screwdriver
blade to pry open the case as		COMPAC_
shown. (=Open" location is		Twistheref-_<:_O..x_
stamped on back of remote		to open

control case 0 Insert batteries positive side down.

Replace cover as follows. 3-Function remote: Insert the 3 tabs at the opposite end and snap shut.

Compact 3-Function remote: Snap shut along both sides.

Dispose of old batteries properly.

Maintenance

Once a Month

Manually operate door. If it is unbalanced or binding, calI for professional garage door service.

Check to be sure door opens and closes fully. Adjust limits and/or force if necessary.

(See pages 28 and 29_)

Repeat the safety reverse tesL Make any necessary adjustments (See page 30).

Schedule

Twice a Year

Check chain tension. Disconnect trolley first. Adjust if necessary (See page 11)o

Once a Year

Oil door rollers, bearings and hinges. The opener does not require additional fubdcation. Do not grease the door tracks..

31