Craftsman 11407 manual Read ALL Instructions, Worklight USE and Care, Model Battery Pack Charger

_IL WARNING! READ AND UNDERSTAND ALL

INSTRUCTIONS. Failure to follow all instructions

listed below, may result in electric shock, fire and/or serious personal injury.

READ ALL INSTRUCTIONS

•Know your worknght. Read operator'smanual carefully. Learn its applications and limitations as well as the specific potential hazards related to this light.

•Use only recommended battery pack with your worklight. Any attempt to use another battery pack will cause damage to your worklight and could possibly explode, cause a fire, or personal injury.

•Use battery only with charger listed.

MODEL	BATTERY PACK	CHARGER
315,114073	130279003	Model No.1425301
	130279005	(Item No. _911041)

(Item No. _911375) Model No. 315.115730

(Item No. 140301003)

Model No. 315.115720

(Item No. 140301001)

•Remove battery pack from worklight before replac- ing bulb or performing any routine maintenance or cleaning.

•Do not disassemble your worklight.

•Do not place worklight or battery pack near fire or heat. They may explode, Also, do not dispose of a worn out battery pack by incinerating.Do not inciner- ate the battery, even if it is severelydamaged or com- pletely worn out. The battery may explode in fire.

•Do not store your worklight in a damp or wet location. Do not store in locations where the

temperature is less than 50°F or more than 100°F. Do not store in outside sheds or in vehicles.

•Do not permit children to use worklight unsuper- vised. It is not a toy. The temperature of the bulb will become hot after being on for only a short period of

time. This hot temperature can cause burn injury if touched and can create sufficient heat to melt some

fabrics.

•If wrapped or in contact with fabrics, the worklight lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the worklight lens to come in contact with anything.

•Keep work area clean. Cluttered areas and benches invite accidents.

•Avoid dangerous environments.

•Keep light dry, clean, and free from oil and grease. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products or any strong solvent to clean your worklight.

•Stay alert. Watch what you are doing and use common sense. Do not rush.

•Check damaged parts. Before further use of this worklight, a part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Do not use worklight if it does not function properly.

•Don'texpose worklight to rain. Water entering a power tool will increase the risk of electric shock or malfunction.

•Stay alert, watch what you are doing and use common sense when operating a worklight. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattentionwhile operating power tools may result in serious personal injury.

•Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enable better control of the tool in unexpected situations. Do not use on a ladder or unstable support.

WORKLIGHT USE AND CARE

•Check for alignment of moving parts, binding of moving parts, mounting, and any other conditions that may affect its operation. A part that is dam- aged should be properly repaired or replaced by an authorized service center. Following this rule will reduce the risk of shock, fire, or serious injury.

•Store worklight out of the reach of children and

other untrained persons. Tools are dangerous in the hands of untrained users,

SERVICE

•Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel may result in a risk of injury.

•When servicing a tool, use only identical replace- ment parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.

3