STOP BLOCK
See Figures 5 and 6.
The stop block is useful as a stop for cutting multiple
pieces to the same length. Itcan be installed on either
table extension on either side of the saw base:
• Slide the stop block onthe back arm of either table
extension, then insert the table extension into the
saw base. See Figure 5.
• Use the small wing screw tosecure the stop block
to the table extension. See Figure 5.
•Loosen the small wing screw and adjust the stop
block the desired distance from the blade for the
cut to be made.
STOPBLOCK
SMALL
WINGSCREW
MITERSAWBASE
EXTENSION Fig. 5
• Tighten smallwing screw securely,
• Make atest cut in scrap material and measure the
length of the workpiece.
• Make any necessary adjustments.
_, WARNING: When using the work clamp with
the stop block, installthe clamp o_ the stop block
side of the blade. This will eliminate the
possibility of thesaw catching the loose end and
kicking up. Failure to heed this warning can
result in serious personal injury.
STOP
BLOCK
Fig. 6