ASSEMBLY INSTRUCTIONS
ASSEMBLING THE HANDLEBARS
Before you can operate the unit, you must install the handlebars.
1.When you unpack the unit, hold the handle bar in the position shown in Figure 1 and slide it onto the lower bars.
2.Align the holes in the handlebar with the holes in the lower bars and insert the bolts through those holes.
3.Hold the handle in place while screwing the knobs onto the bolts (Fig. 2).
4.Tighten the knobs to secure the handlebars in place. NOTE: Do not
5.Check to make sure the bail is assembled into the switch assembly (Fig. 1, Inset A).
NOTE: Take care not to pinch the switch cable when positioning the handlebars.
6.Clip the switch cable to the cable restraint on the lower bar as shown in Figure 1, Inset B.
6