ASSEMBLY INSTRUCTIONS

USING THE CORD RETAINER

There is an extension cord retainer to prevent the extension cord from disconnecting during use. The retainer hangs from the cord guide bar.

NOTE: Do not plug the extension cord into the power source receptacle until the cord is connected to the cord retainer and plugged into the unit.

To use the cord retainer:

1.Fold the extension cord in half, forming a tight loop near the receptacle.

2.Push the loop through the bottom hole in the retainer (Fig. 3).

NOTE: Use a UL-approved extension cord. A 100-foot, 14- gauge cord is recommended. A 50-foot, 16-gauge cord is acceptable.

The cord retainer keeps the extension cord safely to the side of the operator by sliding to the left and right on the guide bar as the unit is moved. Connect your extension cord to the unit as shown in Figure 5.

Fig. 5

Fig. 3

3.Slide the loop over the retaining clip and pull down until the cord fits snugly (Fig. 4).

Fig. 4

7