RULES FOR SAFE OPERATION

this unit. Wear a face or dust mask if the operation is dusty.

Wear heavy long pants, boots, gloves and a long sleeve shirt. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair above shoulder level.

The cutting attachment shield must always be in place while operating the unit as a trimmer. Do not operate unit without both trimming lines extended, and the proper line installed. Do not extend the trimming line beyond the length of the shield.

This unit has a clutch. The cutting attachment remains stationary when the engine is idling. If it does not, have the unit adjusted by an authorized service technician.

Adjust the handle to your size in order to provide the best grip.

Be sure the cutting attachment is not in contact with anything before starting the unit.

Use the unit only in daylight or good artificial light.

Avoid accidental starting. Be in the starting position whenever pulling the starter rope. The operator and unit must be in a stable position while starting. Refer to Starting/Stopping Instructions.

Use the right tool. Only use this tool for its intended purpose.

Do not overreach. Always keep proper footing and balance.

Always hold the unit with both hands when operating. Keep a firm grip on both handles or grips.

Keep hands, face, and feet at a distance from all moving parts. Do not touch or try to stop the cutting attachment when it rotates.

Do not touch the engine, gear housing or muffler. These parts get extremely hot from operation, even after the unit is turned off.

Do not operate the engine faster than the speed needed to cut, trim or edge. Do not run the engine at high speed when not cutting.

Always stop the engine when cutting is delayed or when walking from one cutting location to another.

If you strike or become entangled with a foreign object, stop the engine immediately and check for damage. Do not operate before repairing damage. Do not operate the unit with loose or damaged parts.

Stop the unit, switch the engine to off, and disconnect the spark plug for maintenance or repair.

Use only replacement parts or accessories recommended for this tool that are distributed by Sears or a Craftsman outlet. Use of any replacement parts or accessories purchased elsewhere may be hazardous, and will also void your warranty.

Keep unit clean of vegetation and other materials. They may become lodged between the cutting attachment and shield.

To reduce fire hazard, replace a faulty muffler and spark arrestor. Keep the engine and muffler free from grass, leaves, excessive grease or carbon build up.

OTHER SAFETY WARNINGS

Never store the unit with fuel in the tank, inside a building where fumes may reach an open flame (pilot lights, etc.) or sparks (switches, electrical motors, etc.).

Allow the engine to cool before storing or transporting. Be sure to secure the unit while transporting.

Store the unit in a dry area, locked up or up high to prevent unauthorized use or damage, out of the reach of children.

Never douse or squirt the unit with water or any other liquid. Keep handles dry, clean and free from debris. Clean after each use, see Cleaning and Storage instructions.

Keep these instructions. Refer to them often and use them to instruct other users. If you loan someone this unit, also loan them these instructions.

SAVE THESE INSTRUCTIONS

• SAFETY AND INTERNATIONAL SYMBOLS •

This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information.

SYMBOL MEANING

 

SYMBOL MEANING

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• SAFETY ALERT SYMBOL

 

 

 

 

 

 

• ON/OFF STOP CONTROL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Indicates danger, warning or caution. May be used in

 

 

 

 

 

 

ON / START / RUN

 

 

 

 

 

 

conjunction with other symbols or pictographs.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• ON/OFF STOP CONTROL

 

 

 

 

 

 

 

 

 

 

 

 

 

• READ OPERATOR'S MANUAL

 

 

 

 

 

 

OFF or STOP

 

 

 

 

 

 

WARNING: Read the operator’s manual(s) and

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

follow all warnings and safety instructions. Failure to

 

 

 

 

 

 

• HOT SURFACE

 

 

 

 

 

 

do so can result in serious injury to the operator

 

 

 

 

 

 

WARNING: Do not touch a hot muffler, gear

 

 

 

 

 

 

 

 

 

 

 

 

and/or bystanders.

 

 

 

 

 

 

housing or cylinder. You may get burned. These

 

 

 

 

 

 

 

 

 

 

 

 

 

parts get extremely hot from operation. They remain

 

 

 

 

 

 

 

 

 

 

 

 

 

• WEAR EYE AND HEARING PROTECTION

 

 

 

 

 

 

hot for a short time after the unit is turned off.

 

 

 

 

 

 

WARNING: Thrown objects and loud noise can

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• THROWN OBJECTS AND ROTATING CUTTER

 

 

 

 

 

 

cause severe eye injury and hearing loss. Wear eye

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CAN CAUSE SEVERE INJURY

 

 

 

 

 

 

protection meeting ANSI Z87.1–1989 standards and

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WARNING: Do not operate without the cutting

 

 

 

 

 

 

ear protection when operating this unit. Use a full

 

 

 

 

 

 

 

 

 

 

 

 

face shield when needed.

 

 

 

 

 

 

attachment shield in place. Keep away from the

 

 

 

 

 

 

 

 

 

 

 

 

 

rotating cutting attachment.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• UNLEADED FUEL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Always use clean, fresh unleaded fuel.

 

 

 

 

 

 

• CHOKE CONTROL

 

 

 

 

 

 

 

 

 

 

 

 

 

1. • FULL choke position

 

 

 

 

 

 

 

 

 

 

 

 

 

2. • PARTIAL choke position

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• OIL

 

 

 

 

 

 

3. • RUN choke position

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Refer to operator’s manual for the proper type of oil.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• SHARP BLADE

 

 

 

 

 

 

 

 

 

 

 

 

 

WARNING: Sharp blade on cutting attachment

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• KEEP BYSTANDERS AWAY

 

 

 

 

 

 

shield. To prevent serious injury, do not touch the

 

 

 

 

 

 

WARNING: Keep all bystanders, especially

 

 

 

 

 

 

line cutting blade.

 

 

 

 

 

 

children and pets, at least 50 feet (15 m) from the

 

 

 

 

 

 

 

 

 

 

 

 

 

operating area.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3