ASSEMBLY INSTRUCTIONS

ADJUSTING THE D-HANDLE

1. Locate the wing nut on the D-Handle. Loosen the wing nut enough to loosen the D-Handle (Fig. 1).

NOTE: Do not remove wing nut, washer, or bolt.

2. Rotate the D-Handle to the upright position on the front side of the shaft housing (Fig. 1).

NOTE: The D-handle should slant towards the powerhead of the unit.

3. Hold the unit in the operating position (Fig. 2). If necessary, reposition the D-handle to the location that provides the best grip.

4. Tighten the wing nut until the D-Handle is secure.

Fig. 1

 

 

Fig. 2

 

 

 

 

 

 

5