ASSEMBLY INSTRUCTIONS

INSTALLING AND ADJUSTING THE D-HANDLE To Install

1. Place the D-handle down on to the shaft housing and the bottom clamp so that the handle slants toward the shaft grip (Fig. 1). Place handle and clamp a minimum of 6 inches from the end of the shaft grip.

2. Start screws with a large Flat- head or T-25 Torx screwdriver. Do not tighten until the handle is adjusted.

To Adjust

 

3. While holding the unit in the

 

operating position (Fig. 2),

 

postion the D-handle to the

 

location that provides you the

Fig. 2

best grip.

 

4.Tighten the clamp screws evenly, until the D-handle is secure.

INSTALL LINE TRIMMER ATTACHMENT

NOTE: To make installation easier, place the unit on the ground or on a workbench.

1.Turn knob counterclockwise to loosen coupler (Fig. 15, p. 8).

2.While firmly holding attachment, push it straight into the coupler until the release button snaps into the primary hole (Fig. 16, p. 9).

NOTE: Aligning the release button with the guide recess (Fig. 16, p. 9) will help installation.

3.Turn the knob clockwise to tighten.

LINE TRIMMER APPLICATIONS

Cutting grass and light weeds; edging; and decorative trimming around trees, fences, etc.

KNOW YOUR TRIMMER

 

Spark

Oil Fill Plug

Muffler

Plug

 

 

Shaft Grip

 

Fuel

 

 

Cap

Choke

 

 

On/Off Stop

 

 

Lever

Control

 

 

 

D-Handle

Starter

 

 

Rope

 

 

 

Grip

 

 

Twist & Edge

 

 

 

and Craftsman

Throttle

 

 

Convertible™

 

 

Control

 

 

Coupler

Air Filter

Primer

 

 

 

 

 

Cover

Bulb

Shaft

Housing

Line

Cutting

Blade

Cutting

Attachment Shield

HassleFree lll™

On/Off Stop Control

(4) Screws

Shaft

Housing

Shaft Grip

Minimum 6 Inches

(15.24 cm)

D-Handle

Bottom Clamp

Fig. 1

5