OPERATING INSTRUCTIONS
Craftsman Convertible™ | Primary Hole | Release Button | |||
Coupler | |||||
|
| ||||
|
|
|
|
|
Knob
Guide Recess
Fig. 16
To Install Attachments
NOTE: To make installation easier, place the unit on the ground or on a workbench.
1.Make sure the unit is turned completely off.
2.Turn the knob counterclockwise to loosen the coupler (Fig. 15).
3.While firmly holding the attachment, push it straight into the coupler until the release button (Fig. 16) snaps into the primary hole (Fig. 16). The primary hole is on the opposite side of the coupler from the knob (Fig. 16). Align the release button with the Guide Recess (Fig. 16) to help installation.
4.Turn the knob clockwise to tighten.
CRAFTSMAN CONVERTIBLE™
FEATURE
The coupler allows you to convert this unit for use with the following
•Cultivator
•Blade Edger
•Blower
•Brush Cutter
•Pruner
Upper Shaft
Boom
Attachment
Knob
Fig. 17
CAUTION: Before operating this unit, be sure that the release button is fully snapped into the primary hole (Fig. 16), and that the knob (Fig. 17) is securely tightened.
To Remove Attachments
1.Make sure the unit is turned completely off
2.Turn the knob counterclockwise to loosen the coupler.
3.Press and hold the release button (Fig. 16).
4.While firmly holding the upper shaft boom (Fig. 17), pull the attachment out of the coupler.
CAUTION: These
9