IBM x Series 200 POST error codes, In the following error codes, X can be any number or letter

Setup	Action
Setup and Installation CD	• Be sure the server is supported; all eServers with a startable (bootable) CD-ROM
won’t start.	drive are supported.
	• If the startup (boot) sequence settings have been altered, be sure the CD-ROM is
	first in the boot sequence.
	• If more than one CD-ROM drive is installed, be sure that only one drive is set as
	the primary drive. Start the CD from the primary drive.
ServeRAID program cannot	• Be sure there are no duplicate SCSI IDs or IRQ assignments.
view all installed drives - or -	• Be sure that the hard disk drive is connected properly.
cannot install NOS.
The Operating System	Free up more space on the hard disk.
Installation program
continuously loops.
ServerGuide won't start your	Be sure the NOS CD you have is supported by ServerGuide. See the Setup and
NOS CD.	Installation CD label for a list of NOS versions supported.
Can't install NOS - option is	Either there is no logical drive defined (ServeRAID systems) or the ServerGuide system
grayed out.	partition is not present. Run the setup and configuration program.

TechConnect CD	Action
Can't start TechConnect CD.	Be sure you're starting the CD on a system with Microsoft Windows installed.
Can't view publications from	Be sure you have the Adobe reader installed (available from the TechConnect CD).
TechConnect CD, or text is
unreadable.
Diskette Factory CD	Action
Get "time out" or "Unknown	Be sure you have access to the Internet through FTP directly.
host" errors
POST error codes

In the following error codes, X can be any number or letter.

Error Code/Symptom		FRU/Action
062	1.	Run Configuration/Setup
(Three consecutive boot	2.	Battery
failures using the default	3.	System Board
configuration.)	4.	Microprocessor
101, 102, 106	1.	System Board
(System and microprocessor
error)
111	1.	Failing adapter
	2.	DIMM
(Channel check error)	3.	System board

94Hardware Maintenance Manual: xSeries 200