IBM x Series 200 manual Removing the bezel, Cover-release latch Key lock

Cover-release latch

Key lock

Complete the following steps to remove the side cover of the server:

1.Review the information in “Before you begin” on page 38.

2.Turn off the server and peripheral devices and disconnect all external cables and power cords.

3.If necessary, unlock the server cover.

4.Pull out on the cover-release latch, which will slide the cover toward the rear of the server about 12.7 mm (1/2 in.). Then, remove the cover from the server.

5.Pull out on the cover-release tab at the rear of the server; then, slide the cover toward the front of the server and remove it.

Attention: For proper cooling and airflow, replace the cover before turning on the server. Operating the server for extended periods of time (over 30 minutes) with the cover removed might damage server components.

Removing the bezel

The following illustration shows how to remove the bezel from the server.

Note: The illustrations in this document might differ slightly from your hardware.

Installing options 41