Error code |
| Description |
(hex) |
| |
|
| |
|
| |
0x00 | Explanation: The driver could not register the specified interrupt. | |
| Action: Using the Configuration/Setup Utility program, make sure that a | |
| PCI interrupt is assigned to your Ethernet card, and that Ethernet is enabled. | |
|
| |
0x01 | Explanation: One of the PCI cards did not get the required resources. | |
| Action: Using the Configuration/Setup Utility program, make sure that a | |
| PCI interrupt is assigned to your Ethernet card, and that Ethernet is enabled. | |
|
| |
0x02 | Explanation: Bad node address (multicast address). | |
| Action: Make sure the locally administered address is valid, if one is | |
| specified. The address can not be a multicast address. | |
|
| |
0x03 | Explanation: Failed | |
| Action: Make sure a cable is attached to the Ethernet connector. If the | |
| problem persists, call for service. | |
|
| |
0x0D | Explanation: Could not allocate enough memory for transmit queues. | |
| Action: | |
| 1. | From the Windows NT desktop, select Start gControl Panel g |
|
| Networks gAdapters. |
| 2. | Select your IBM Ethernet adapter from the list. |
| 3. | Select Properties gAdvanced. |
| 4. | Lower the resource values that apply to the transmit queue. |
|
| |
0x0E | Explanation: Could not allocate enough memory for receive queue. | |
| Action: | |
| 1. | Fromgthe Windows NT desktop, select Start gControl Panel |
|
| Networks gAdapters. |
| 2. | Select your IBM Ethernet adapter from the list. |
| 3. | Select Properties gAdvanced. |
| 4. | Lower the resource values that apply to the receive queue. |
|
| |
0x0F | Explanation: Could not allocate enough memory for other structures. | |
| Action: | |
| 1. | From the Windows NT desktop, select Start gControl Panel g |
|
| Networks gAdapters. |
| 2. | Select your IBM Ethernet adapter from the list. |
| 3. | Select Properties gAdvanced. |
| 4. | Lower the value for the resource named in the message. |
|
| |
0x10 | Explanation: Did not find any Ethernet controllers. | |
| Action: Using the Configuration/Setup Utility program, make sure that | |
| Ethernet is enabled. | |
|
| |
0x11 | Explanation: Multiple Ethernet controllers found, but none matched the | |
| required ID. | |
| Action: Using the Configuration/Setup Utility program, make sure that | |
| Ethernet is enabled. | |
|
| |
0x13 | Explanation: Did not find any Ethernet controllers that matched the required | |
| subven/subdev. | |
| Action: Using the Configuration/Setup Utility program, make sure that | |
| Ethernet is enabled. | |
|
|
|
Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller.
