Table 11. Ethernet RJ-45 connector pin-number assignments..

3.In Windows NT, VLANs cannot be implemented on controllers that have been configured for teaming options. NetWare can support teaming options and VLANs on the same adapters.

Complete the following steps to join a VLAN from Windows NT 4.0:

1.Create a VLAN on the switch. Use the parameters you assign there to join the VLAN from the server. Refer to your switch documentation for more information.

2.Double-click the Network icon in the Control Panel window.

3.On the Adapters tab, select the adapter you want to be on the VLAN and select Properties.

4.In IBMSet, select Join VLAN. Note that VLANs cannot be assigned to adapters that are already defined to have an adapter teaming option.

5.Enter the VLAN ID and VLAN name. The VLAN ID must match the VLAN ID of the switch. The ID range is from 1 to 1000. The VLAN name is for information only and does not need to match the name on the switch.

6.Select Join VLAN. Repeat steps 3 through 5 for each VLAN you want the server to join. The VLANs you add are listed on the Adapters tab.

7.Select Close and restart the computer.

Ethernet connector: There is an RJ-45 Ethernet connector on the back of the server, see “I/O connector locations” on page 60 for the location of this connector. The following table shows the pin-number assignments for the Ethernet connector.

8 1

Table 11. Ethernet RJ-45 connector pin-number assignments..

Pin

Signal

Pin

Signal

 

 

 

 

1

+ Transmit data

5

Not connected

 

 

 

 

2

- Transmit data

6

- Receive data

 

 

 

 

3

+ Receive data

7

Not connected

 

 

 

 

4

Not connected

8

Not connected

 

 

 

 

Universal Serial Bus connectors

Your server has two Universal Serial Bus (USB) connectors, which are configured automatically. USB is a serial interface standard for telephony and multimedia devices. It uses Plug and Play technology to determine the type of device that is attached to the connector.

Notes:

1.If you attach a standard (non-USB) keyboard to the keyboard connector, the USB connectors and devices will be disabled during the power-on self-test.

2.If you install a USB keyboard that has a mouse connector, the USB keyboard emulates a mouse, and you will not be able to disable the mouse settings in the Configuration/Setup Utility program.

68Hardware Maintenance Manual: xSeries 200

Page 76
Image 76
IBM x Series 200 manual Universal Serial Bus connectors, Ethernet RJ-45 connector pin-number assignments