IBM x Series 200 manual Error symptoms, Hardware Maintenance Manual xSeries

Error Code/Symptom		FRU/Action
301-XXX-000	1.	Keyboard
(Failed Keyboard test)
405-XXX-000	1.	Verify that Ethernet is not disabled in BIOS.
(Failed Ethernet test on	2.	System Board
controller on the System
Board)
405-XXX-00N	1.	Adapter in PCI slot N.
(Failed Ethernet test on	2.	System Board
adapter in PCI slot N)
415-XXX-000	1.	Cable
(Failed Modem test)	2.	Modem
	3.	System Board
Error symptoms
General		FRU/Action
CD is not working properly.	1.	Clean the CD.
	2.	Run CD-ROM diagnostics.
	3.	CD-ROM Drive
CD-ROM drive tray is not	1.	Insert the end of a paper clip into the manual tray-release opening.
working.	2.	Run CD-ROM diagnostics.
(The server must be	3.	CD-ROM Drive
powered-on.)
CD-ROM drive is not	1.	Run Configuration/Setup, enable primary IDE channel.
recognized.	2.	Check cables and jumpers.
	3.	Check for correct device driver.
	4.	Run CD-ROM diagnostics.
	5.	CD-ROM drive
	6.	System Board
Power switch does not work.	1.	Verify that switch number 5 of switch block is Off.
	2.	Power Switch Assembly
	3.	System Board
CD-ROM drive cable is not	1.	Make sure CD-ROM drive cable is plugged in.
plugged in.

92Hardware Maintenance Manual: xSeries 200