Complete the following steps to remove the support bracket assembly:
1.Review the information in “Before you begin” on page 38.
2.Turn off the server and peripheral devices and disconnect all external cables and power cords.
3.Disconnect the support bracket assembly fan cable from the connector (SYSFA3) on the system board. For the location of the fan connector, see “System board internal cable connectors” on page 36.
4.Pull out, about 152.4 mm (6 in.), on the end of the support bracket assembly located at the rear of the server.
5.Pull the front end of the support bracket assembly away from the server and place the assembly aside.
To reinstall the support bracket assembly, reverse the previous steps.
Working with adapters
Your server comes with adapter connectors, called slots. The AGP video adapter is installed in the AGP slot. You can install up to five PCI adapters in PCI slots 1 through 5. All PCI expansion slots are
Note: The illustrations in this document might differ slightly from your hardware.
The following illustration shows the location of the system expansion slots on the system and PCI extender boards.
Installing options 43
