
assembly” on page 42 and “System board internal cable connectors” on page 36 for the location of the fan cable connector.
4.Use a screwdriver to gently pry the filler panel and EMC shield away from the server.
Note: If you are installing a drive that is a laser product, observe the following safety precaution:
CAUTION:
When laser products (such as
•Do not remove the covers. Removing the covers of the laser product could result in exposure to hazardous laser radiation. There are no serviceable parts inside the device.
•Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.
DANGER: Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the following. Laser radiation when open. Do not stare into the beam, do not view directly with optical instruments, and avoid direct exposure to the beam.
5.Touch the
6.Set any jumpers or switches on the drive according to the documentation that comes with the drive.
7.Install the drive.
•If you are installing a
•If you are installing a
Note: You can only install a
8.Cable the drive.
•If the drive is an IDE device, plug one connector of the IDE signal cable into the back of the drive and the other end of the cable into the IDE connector (IDE1) on the system board. For the location of the IDE connectors, see “System board internal cable connectors” on page 36.
•If the drive is a SCSI device, plug one connector of the SCSI signal cable into the back of the drive and the other end of the cable into the SCSI adapter. See “Installing an adapter” on page 45.
50Hardware Maintenance Manual: xSeries 200