IBM x Series 200 manual Hardware Maintenance Manual xSeries

Error Code/Symptom		FRU/Action
015-XXX-198	1.	Remove USB devices from USB1 and USB2
(USB device connected	2. Re-run test
during USB test)	3.	System Board
020-XXX-000	1.	System Board
(Failed PCI Interface test)
030-XXX-000	1.	System Board
(Failed Internal SCSI interface
test)
030-XXX-00N	1.	Adapter in Slot N
(Failed SCSI test on PCI slot
N. Check system error log
before replacing a FRU.)
035-XXX-099	1.	No adapters were found.
	2.	If adapter is installed re-check connection.
035-XXX-S99	1.	Adapter
(Failed RAID test on PCI slot	2.	SCSI Backplane
S. S = number of failing PCI	3.	Cable
slot. Check System Error Log
before replacing a FRU.)
035-XXX-SNN	1.	Fixed Disk with SCSI ID NN on RAID adapter in PCI slot S.
(Check System Error Log
before replacing a FRU. S =
number of failing PCI slot;
NN = SCSI ID of failing fixed
disk.)
035-253-S99	1.	ServeRAID Adapter in slot S is not configured properly. Obtain the basic and
(RAID adapter initialization		extended configuration status and refer to the ServeRAID Hardware Maintenance
		Manual for more information.
failure)	2.	Cable
	3.	Adapter
075-XXX-000	1.	Power Supply
(Failed Power Supply test)
089-XXX-001	1.	Microprocessor
(Failed Microprocessor test)
180-XXX-003	1.	System Board
(Failed System Board LED
test)
201-XXX-0NN	1.	DIMM Location J1-J4
(Failed Memory test, see	2.	Memory card
"Memory Settings" on page
31.) NN = DIMM location.

90Hardware Maintenance Manual: xSeries 200