6.Gently slide the floppy disk drive toward the front of the server and lift it out.
Button kit
Before you begin:
•Read “Safety information” on page 105.
•Review the information in “Before you begin” on page 38.
To remove the button kit, do the following:
1.
2.Unplug the server.
3.Remove the cover (see “Removing the side cover” on page 40).
4.Remove the front bezel (see “Removing the bezel” on page 41).
5.Remove the
6.Disconnect the cable of the button kit from the system board.
7.Place a screwdriver against the bottom release latch of the button kit and gently press upward and slide the latch through the aperture.
8.Gently pinch together the upper release latches and slide the latches through the aperture and remove the button kit.
Guide assembly / speaker
Before you begin:
•Read “Safety information” on page 105.
•Review the information in “Before you begin” on page 38.
