8.Place the adapter,
9.Set any jumpers or switches as described by the adapter manufacturer.
10.To install the adapter, carefully grasp the adapter by its top edge or upper corners, and align it with the expansion slot guides; then, press the adapter firmly into the PCI expansion slot.
Attention: When you install an adapter in the server, be sure that it is completely and correctly seated in the PCI expansion slot before you turn on the server. Incomplete insertion might cause damage to the system board or the adapter.
11.Connect required cables to the adapter.
Attention: Route cables so that they do not block the flow of air from the fans.
12.If you have another adapter or other options to install, do so now.
13.If you have installed a
14.Reinstall the rear adapter retaining bracket; then, rotate the bracket to the closed (locked) position.
15.Reinstall the side cover, see “Installing the cover” on page 59 for details.
16.Reconnect the external cables and power cords; then, turn on the peripheral devices and the server.
Installing a SCSI or ServeRAID adapter (some models)
Complete the following steps to install a SCSI or ServeRAID adapter:
1.If you have not already installed the SCSI adapter, complete steps 1 through 10 of “Installing an adapter” on page 45. Then, return here to complete the installation.
SCSI signal cable
Adapter |
|
|
|
|
retaining |
|
|
|
|
bracket |
|
|
|
|
SCSI signal |
|
|
|
|
cable connector |
|
|
|
|
SCSI activity |
|
|
|
|
indicator cable | SCSI |
|
|
|
connector |
|
|
| |
Adapter |
| SCSI | Adapter | |
| SCSI | |||
|
| |||
|
| activity | LED | support |
|
| indicator | (J3) | bracket |
|
| cable |
|
|
46Hardware Maintenance Manual: xSeries 200
