AEG PV.630 manual Installation of the COM Server

Protect PV.630 Operating Instructions

Connections:

CN1:	Internal inverter bus and power supply
MOD1:	Ethernet connection
CN5:	Interface for firmware update
Configuration jumpers:
CN3:	All closed (default)

LED signals:

Green LED (H1):

The green LED on the assembly indicates the global status of the assembly. The following signals are possible:

LED￿	Jumper	Meaning
Flashing	CN3	Start-up/error
On	CN3	Ready
Flickering	CN3	Ethernet  CAN communication

Green network LED (MOD1):

The green LED indicates communication on the network.

Yellow network LED (MOD1):

The yellow LED remains on permanently if an Ethernet network is connected.

7.2.4Installation of the COM Server

The COM server uses a communication module from Digi (“Digi Connect ME”). In order to communicate via the COM server, it must be integrated into the network and a virtual COM port must be set up on a computer. The “Digi Device Discovery” tool and a Digi RealPort driver are required for this purpose. You can find these tools at www.digi.com/support or at www.aegps.com.

Network factory settings for the COM server:

IP address:	10.10.10.0
Subnet mask:	255.255.0.0
Default gateway:	0.0.0.0

8000047961 BAL 57 of 72