AEG PV.630 manual Signalling, Keyboard Operation, LEDs, Acoustic signal generator

Models: PV.630

1 128
Download 128 pages 35.18 Kb
Page 66
Image 66

Protect PV.630 Operating Instructions

8.1.1 Signalling

 

LEDs:

 

Red, permanently ON:

Deactivating fault

 

(must be acknowledged via the menu)

Red, flashing:

Self-acknowledging deactivating fault

Yellow, flashing:

Self-acknowledging message

Green OFF:

INV in sleep mode

Green, flashing (1 Hz):

INV waiting for feed conditions

Green, flashing (0.5Hz):

INV feeding into mains with derating

Green, permanently ON:

INV feeding into mains

Acoustic signal generator:

Signal generator ON: Urgent message and equipment fault

8.1.2 Keyboard Operation

You can use the ENTER key to open and close submenus and to acknowledge control functions and parameters.

The 4 display keys are assigned to different functions. The key functions that are currently active are represented as symbols which can be found in a small framed area on the right-hand side of the LCD.

In the “Operating display” and “Inverter” menus, you can switch the inverter on and off using the general keys. The keyboard symbols in the menu indicate the control function which is currently availa- ble. If a switch-off procedure has been initiated, you must confirm it by means of a security prompt in order to avoid inadvertent switch- ing off. The general control system of the inverter can be blocked and protected with a password.

If a unit fault occurs, refer to the “Inverter” menu, where the cause is specified. After eliminating the cause, acknowledge the fault in the menu. You can then switch the individual converters back on again.￿

You can acknowledge the acoustic signal generator using the key- board. On the LCD operating display you will find a special acknowledgement key represented by a loudspeaker symbol. In all other menus, you can press any key (even a key to which no func- tions have been assigned) to acknowledge the generator. If the number of messages or faults increases, the acknowledgement is cancelled. You can impose a general block that inhibits the acous- tic signal generator in the event of a fault and inhibits the clicking sound when you press a key.

62 of 72

8000047961 BAL

Page 66
Image 66
AEG PV.630 manual Signalling, Keyboard Operation, LEDs, Acoustic signal generator