AEG PV.630 manual Using a Crane to Transport and Install the System, Preparations

Protect PV.630 Installation and Start-up

i

Compliance with the requirements of IEC 60364-7-729 is mandatory when installing the system.

Make sure that there is a space of at least 500 mm in front of the system (ensure compliance with national re- quirements, which may be different) when its doors are open to ensure an escape route.

There must be a minimum clearance of 400 mm above the system to allow air to escape.

ATTENTION

Insufficient dissipation of waste heat can damage the system!

Dissipate the waste heat in accordance with the manu- facturer's specifications.

4.4Using a Crane to Transport and Install the System

WARNING

Risk of accident due to suspended loads!

Possibility of death or very serious injury.

Only trained personnel working specifically in the area of transport may transport the system.

Secure the danger zone.

Never stand under suspended loads.

Make sure that nobody stands under suspended loads.

Wear personal protective equipment.

Preparations￿

Please note the following before transport:

During crane transport, only use the transport rails (1) (optional) intended for this purpose.

Only use ropes which allow an angle of at least 45° between rope and cabinet roof.

Do not exceed the permissible load-bearing capacity of each rope. The load-bearing capacity must be dimensioned as fol- lows:

Load-bearing capacity per rope ≥ 0.5 x total weight of sys- tem or of individual components

The total weight of the system or of the individual components is specified in the technical data sheet.

Do not exceed the permissible weight that can be carried by the crane.

Use one rope per transport eyelet.￿

Be aware of the equipment's centre of gravity.

80000047963 BAL 7 of 21