IBM x Series 200 manual Video connector, Ultra 3/160 SCSI connector some models

locations” on page 60 for the location of the MIDI connector. The following table shows the pin-number assignments for the MIDI connector.

81

159

Table 13. MIDI connector pin-number assignments.

Pin	Signal		Pin	Signal		Pin	Signal
1	+5 V		6	Joystick 1	-- Y	11	Joystick 2 -- X
2	Joystick 1	Switch A	7	Joystick 1	Switch B	12	MIDI - OUT
3	Joystick 1	-- X	8	+5 V		13	Joystick 2 -- Y
4	Switch Common		9	+5 V		14	Joystick 2 Switch D
5	Switches Common		10	Joystick 2 Switch C		15	MIDI - IN

Video connector

Your server uses an AGP adapter located in the AGP slot on the system board. There is a 15-pin analog video connector located on the rear of the server. See “I/O connector locations” on page 60 for the location of this connector. The table below shows the pin-number assignments for the video connector.

5 1

15 11

Table 14. Video connector pin-number assignments.

Pin	Signal	Pin	Signal	Pin	Signal
1	Red	6	Ground	11	Not connected
2	Green or monochrome	7	Ground	12	DDC SDA
3	Blue	8	Ground	13	Horizontal synchronization
					(Hsync)
4	Not connected	9	+5 V dc	14	Vertical synchronization (Vsync)
			DDC
5	Ground	10	Ground	15	DDC SCL

Ultra 3/160 SCSI connector (some models)

Some xSeries 200 server models come with a SCSI adapter, which supports a single Ultra 3/160/MB SCSI channel in a full-featured PCI 2.1-/2.2-compliant bus master package. This configuration supports a zero wait state, 32-bit memory transfers at 160 Mbytes/second, when LVD SCSI peripherals are attached. This channel supports up to 15 SCSI devices. In addition, this adapter uses:

•Double-transition clocking to achieve high transfer rates

70Hardware Maintenance Manual: xSeries 200