IBM x Series 200 manual No beep symptoms, Hardware Maintenance Manual xSeries

Beep/Symptom		FRU/Action
3-3-1	1.	DIMM
(Memory size	2.	System board
mismatch occurred, see	3.	Battery
"Memory Settings" on
page 31)
3-3-2	1.	Disconnect the server power cord from outlet, wait 30 seconds and retry.
(Critical SMBUS error	2.	System Board
occurred) (I2C bus	3.	DIMMs
error)	4.	Power Supply
	5.	12C Cable
3-3-3	1.	Install or reseat the memory modules, then do a 3 boot reset. (See “Using the
(No operational		Configuration/Setup Utility program” on page 29.)
	2.	DIMMs
memory in system)
	3.	System Board
Two Short Beeps	1.	Run Diagnostics
(Information only, the	2.	Run Configuration/Setup
configuration has
changed)
Three Short Beeps	1.	DIMM
	2.	System Board
One Continuous Beep	1.	Processor
	2.	System Board
Repeating Short Beeps	1.	Keyboard
	2.	System Board
One Long and One	1.	Video adapter (if present)
Short Beep	2.	System Board
One Long and Two	1.	Video adapter (if present)
Short Beeps	2.	System Board
Two Long and Two	1.	Video adapter
Short Beeps

No beep symptoms

No Beep Symptom		FRU/Action
No beep and the system	1.	Check speaker cables
operates correctly.	2.	Speaker
	3.	System board
No Beeps occur after	1.	Check speaker connections
successfully completing	2.	Speaker
POST
	3.	System board

88Hardware Maintenance Manual: xSeries 200