IBM x Series 200 manual Diagnostic error codes

No Beep Symptom		FRU/Action
No ac power	1.	Check the power cord.
	2.	Power supply.
No beep and no video	1.	See “Undetermined problems” on page 100

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197,do not replace a FRU. The description for these error codes are:

000The test passed.

195The Esc key was pressed to abort the test.

197This is a warning error and may not indicate a hardware failure. For all error codes, replace/follow the FRU/Action indicated.

Error Code/Symptom		FRU/Action
001-XXX-000	1.	System Board
(Failed core tests)
001-XXX-001	1.	System Board
(Failed core tests)
001-250-000	1.	System Board
(Failed System Board ECC)
001-250-001	1.	System Board
(Failed System Board ECC)
005-XXX-000	1.	Video Adapter (if installed)
(Failed Video test)	2.	System Board
011-XXX-000	1.	System Board
(Failed COM1 Serial Port test)
011-XXX-001	1.	System Board
(Failed COM2 Serial Port test)
014-XXX-000	1.	System Board
(Failed Parallel Port test)
015-XXX-001	1.	System Board
(USB interface not found,
board damaged)
015-XXX-015	1.	Make sure parallel port is not disabled
(Failed USB External	2.	Re-run USB External Loopback test
Loopback test)	3.	System Board

Symptom-to-FRU index 89