Barco R9040111 Cleaning the Lens, Battery installation in the RCU, Inserting the Batteries

Models: R9040111 R9040101 R9040100 R9040110

1 82
Download 82 pages 3.45 Kb
Page 15
Image 15
Cleaning the Lens

Installation Guidelines

Image 3

Image 4

Cleaning the Lens

To minimize the possibility of damaging the optical coating or scratching exposed lens surface, we have developed recommendations for cleaning the lens. FIRST, we recommend you try to remove any material from the lens by blowing it off with clean, dry deionized air. DO NOT use any liquid to clean the lenses.

A TorayseeTM cloth is included with the lens kit.

Proceed as follows :

1.Always wipe lenses with a CLEAN TorayseeTM cloth.

2.Always wipe lenses in a single direction. Do not wipe back and forwards across the lens surface as this tends to grind dirt into the coating.

3.Do not leave cleaning cloth in either an open room or lab coat pocket, as doing so can contaminate the cloth.

4.If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty cloth.

5.Do not use fabric softener when washing the cleaning cloth or softener sheets when drying the cloth.

6.Do not use liquid cleaners on the cloth as doing so will contaminate the cloth.

Order number for a new TorayseeTM cloth : R379058.

Other lenses can also be cleaned safely with this TorayseeTM cloth.

Battery installation in the RCU.

Inserting the Batteries.

Two batteries are packed together with the RCU. Before using your RCU, install first these batteries.

1Remove the battery cover on the backside by pushing the handle a little towards the bottom of the RCU.

2Lift up the top side of the cover at the same time.

3Insert the batteries as indicated in the RCU.

4Put the battery cover on its place.

How to replace the batteries in the RCU ?

To replace the batteries :

1Remove the battery cover on the backside by pushing the handle a little towards the bottom of the RCU.

2Lift up the top side of the cover at the same time.

3Push on the + side of the battery towards the - side

4Lift up the battery at the same time.

5Repeat for the second battery.

6Insert the batteries as indicated in the RCU (battery type AA or LR6 or equivalent).

7Put the battery cover on its place.

5976135 BARCOSIM 6 21032000

 

2-5

 

Page 15
Image 15
Barco R9040111 Cleaning the Lens, Battery installation in the RCU, Inserting the Batteries, Installation Guidelines