Barco R9040111 Switching Off, Switching to Stand-by Warning, Input Source Connection, Connections

Connections

Switching Off

To switch off:

-First press STANDBY key for 2 seconds. When the message 'Saving data, please wait' is displayed, do not press any longer on the standby key otherwise the projector will restart. Let cool down the projector at least 10 min.

-Switch off the projector with the power switch.

Switching to Stand-by Warning

When switching to standby, it is possible to restart within the first 5sec.. When not restarted within these first 5 sec., the projector waits for 1 min. to restart again. During this period the LED display will show a jumping square with a dash. After one minute, two dashes will be displayed and the projector can restart.

Input Source Connection

Input facilities

For a standard SIM6:

5-cable input Computer

Optional inputs:

Video S-Video

Serial digital input

IEEE 1394 (not yet active)

Input Selection

This can be manually or automatically.

When 'automatic' is selected in the Input slots menu, by starting up the projector, it searches for an input source by scanningthe inputs one by one. If only one source is found, this source will be projected. If different sources are found, the priority is as follow (for a SIM6 with all input option) :

1.Video

2.S-Video

3.5 Cable input

4.Computer input

SDI input and IEEE input are never automatically selected.

Note : When a RCVDS is connected to the projector, the 'Automatic' selection is disabled.

Set up of the input selection

1Press ENTER to start up the adjustment mode.

2Press the cursor key  or  to select 'Installation' (menu 1).

3Press ENTER to display the Installation menu.

4Press the cursor key  or  to select 'Input Slots' (menu 2).

5Press ENTER to display the Input slots menu.

6Press the cursor key  or  to select 'Input Slots' (menu 3).

7Press ENTER to toggle between [Manual] or [Automatic].

8Press EXIT several times to leave the adjustment mode.

ADJUSTMENT MODE

Select a path from below :

RANDOM ACCESS

INSTALLATION

Select with  or 

then <ENTER> <EXIT> to return.

INSTALLATION

INPUT SLOTS

Select with  or 

then <ENTER> <EXIT> to return.

INPUT SLOTS

SLOT SELECTOR [Automatic]

x1. RGB [HS&VS] - 2. RGB [HS&VS] - 3. VIDEO

- 4. S-VIDEO

- 5. DIGITAL INPUT - 6. IEEE 1394

Select with  or  <ENTER> to toggle <EXIT> to return.

menu 1 menu 2 menu 3

Input Facilities, RCVDS05 connected.

When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module have to be connected to the 5 cable input (slot 1) of the projector.

To switch the projector in the 5-cable mode see chapter 'Installation mode'.

5976135 BARCOSIM 6 21032000 4-3