Mazda Not a Manual manual QAdvanced Key Maintenance

Knowing Your Mazda

Advanced Keyless Entry and Start System

qAdvanced Key Maintenance

CAUTION

ØMake sure the battery is installed with the correct pole facing upward. Battery leakage could occur if it is not installed correctly.

ØWhen replacing the battery, be careful not to touch any of the internal circuitry and electrical terminals, bend the electrical terminals, or get dirt in the transmitter as the transmitter could be damaged.

ØThere is the danger of explosion if the battery is not correctly replaced.

ØReplace only with the same type battery (CR2025 or equivalent).

ØDispose of used batteries according to the following instructions.

ØInsulate the plus and minus terminals of the battery using cellophane or equivalent tape.

ØNever disassemble.

ØNever throw the battery into fire or water.

ØNever deform or crush.

The following conditions indicate that the battery power is low:

lThe KEY indicator light (green) flashes in the instrument cluster for about 30 seconds after the engine is turned off.

lThe system does not operate and the operation indicator light on the transmitter does not flash when the buttons are pressed.

lThe system's operational range is reduced.

Replacing the battery at an Authorized Mazda Dealer is recommended to prevent damage to the advanced key. If replacing the battery by yourself, follow the instruction below.

Replacing the advanced key battery

1. Pull out the auxiliary key.

2.Insert a small, flathead screwdriver into the groove shown in the figure and rotate the screwdriver to open the cover slightly.

3-5