Mazda Not a Manual manual Audio System

Interior Comfort

Audio System

“UPDATING xx%” is displayed when the SIRIUS channel map is changed. If the unit is initialized or the user contract content is changed, “UPDATING” is displayed. Updating could take as long as three minutes depending on the geographical area. When the unit is in an initialized state, channel 184 is displayed after the display indicates “UPDATING 100%”. If the SIRIUS channel map or the user contract content is changed, the channel prior to the change is displayed after “UPDATING” is displayed. After the initialization display, it may take as long as 12 seconds to receive channel 184.

NOTE

Do not perform the following operation while “UPDATING” is displayed. Otherwise, the updating procedure will be cancelled.

lTurning off the audio power l Switching to other modes

l Switching the ignition off

When the SIRIUS mode is switched to another mode, or when the power is turned off, the present channel which is being received is stored as the last channel.

Channel selection

Turning the manual tuning dial allows you to select the desired receiving channel.

lTurn the knob clockwise: Channel Up l Turn the knob counterclockwise:

Channel Down

Unsubscribed channel

When a selected station has not been subscribed to, the display indicates the following:

[CALL 888] and [539 SIRI] (Flashes alternately)

NOTE

When the subscription contract is canceled, all of the channels including channel 184 appear as unsubscribed.

Invalid channel

When a selected channel is not broadcasting, [SR (bank number) INVALID] is displayed for one second, followed by [SR (bank number) CHANNEL], which is also displayed for one second. The display then returns to the previous valid channel.

NOTE

If the last channel selected has become unavailable because of a channel update the above indication is displayed until any button is pressed.

Preset channel programming

(Programming with “channel number” display)

1.Select the desired channel to be programmed. At this point, the following is displayed:

[SR (bank number) (channel number)]

2.Keep pressing the channel preset button for 1.5 seconds or more.

The programming process is complete after the channel number flashes. Then, [SR (bank number)] is displayed and a beep sound is heard at the same time.

3.[SR (bank number) CH (preset number) (channel number)] are displayed.

6-37