Mazda Not a Manual manual Removal

Maintenance and Care

Owner Maintenance

5. Disconnect the bulb from the socket.

6.Install the new bulb in the reverse order of the removal procedure.

Front turn signal lights/Parking lights

1.If you are changing the right bulb, start the engine, turn the steering wheel all the way to the right, and turn off engine. If you are changing the left bulb, turn the steering wheel to the left, and turn off engine.

2.Make sure the turn signal switch is off.

3.Turn the center section of the plastic retainer counterclockwise and remove the retainers and partially peel back the mudguard.

Removal

5. Disconnect the bulb from the socket.

6.Install the new bulb in the reverse order of the removal procedure.

Rear turn signal lights, Reverse lights, Brake lights/Taillights, Rear side marker lights

Rear side marker lights

Due to the complexity and difficulty of the procedure, the LED bulbs must be replaced by an Authorized Mazda Dealer.

NOTE

LED bulb replacement is not possible because it is built into the unit. Replace the unit.

Rear turn signal lights, Reverse lights, Brake lights/Taillights

1.Make sure the ignition is switched off and the applicable light switch is off.

2.Lift the trunk.

Installation

4.Turn the socket and bulb assembly counterclockwise and remove it.

8-43