CHECK FOR DAMAGED OR
WORN PARTS
Contact Sears Service Center for re- placement of damaged or worn parts.
•ON/STOP Switch - Ensure ON/STOP switch functions properly by pushing and releasing the switch. Make sure engine stops. Wait 5 seconds be- fore attempting to restart unit to al- low switch to reset. Restart engine and continue.
•Fuel Tank - Discontinue use of unit if fuel tank shows signs of damage or leaks.
•Debris Shield - Discontinue use of unit if debris shield is damaged.
INSPECT AND CLEAN UNIT AND LABELS
•After each use, inspect complete unit for loose or damaged parts. C_ean the unit and _abe_susing a damp cloth with a mild detergent.
•Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine per- formance and increases fuel consump- tion and harmful emissions. Always clean after every 5 hours of operation.
1.Clean the cover and the area
around it to keep dirt from fairing into the carburetor chamber when the cover is removed.
2.Remove parts as illustrated.
NOTE: To avoid creating a fire hazard or producing harmful evaporative emissions, do not clean filter in gaso- line or other flammable solvent.
3.Wash the filter in soap and water.
4.AItow filter to dry.
REPLACING THE UNE
1.Push and release the engine ON/STOP switch.
2.Disconnect the spark plug wire.
3.Remove spool by firmly pulling on tap button.
4.Clean entire surface of hub and spool.
5.Replace with
(2 mm) diameter Craftsmen@ brand line.
_ WARNING: Never use wire,
rope, string, etc., which can break off and become a dangerous missile.
6.Insert one end of line about 1/2 inch (1 cm) into the small hole on the inside of the spool.
5.Add a few drops of oil to the filter; squeeze the filter to distribute oil.
6.Replace parts.
| _f__r | Filts_rews |
Air Filter / | v | |
Cover |
| |
INSPECT MUFFLER | AND SPARK | |
ARRESTING | SCREEN | |
_WARNING: | The muffler on this | |
product contains chemicals known to the State of Califoroia to cause cancer.
As your unit is used, carbon deposits build up on the muffler and spark ar- resting screen. For normal homeown- er use. however, the muffler and spark arresting screen will not require any service. After 50 hours of use, we rec- ommend that your muffler be serviced or replaced by your Sears Service Center.
REPLACE SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Ignition timing is fixed and nonadiustable.
1.Twist. then pull off spark plug boot.
2.Remove spark plug from cylinder and discard.
3.Replace with Champion
4.Reinstall the spark pll_j boot.
7.Wind line evenly and tightly onto
spool. Wind in the direction of the arrow on the spool.
HoleSpool
Small _.__,..
Line_ Notch
Line exit hole
