REMOVING TRIMMER ATTACH-
MENT (OR OTHER OPTIONAL AT- TACHMENTS)
CAUTION: When removing or instal- ling attachments, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Upper Shaft
Coupler
.OOSEN
Attachment
TIGHTENKnob
2.Press and hold the locking/release button.
Locking/Release
Button
erator's manual. Using the wrong hole
could lead to serious injury or damage to the unit.
Secondary Hole
Locking/Release
Button in Primary Hole
OPERATING INSTRUCTIONS
To maximize operating efficiency, do
not run the engine for longer than 1 minute at a time at full throttle.
OPERATING POSITION
ALWAYS USE:
Hearing |
|
Protection | Eye Protection |
C°uF | Upper Shaft |
Attachment |
|
3.While securely holding the engine and upper shaft, pull the attach- ment straight out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1.Remove the shaft cap from tile at- tachment (if present).
2.Position locking/release button of attachment into guide recess of coupler.
3.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the
knob securely by turning clock- wise.
Coupler Primary Hole
Guide Recess
Upper Locking/ Attachment
Shaft Release
Button
_WARNING: | Make sure the lock- |
ing/release button is locked in the pri- mary hole and the knob is securely tightened before operating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment op-
Long
Pants
Heavy
Shoes
Cut from your left to your right.
dllWARNING: Always wear eye
protection and hearing protection. Never lean over the trimmer head. Rocks or
debris can ricochet or be thrown into
eyes and face and cause blindness or other serious injury.
When operating unit, stand as shown and check for the following:
•Wear eye protection, hearing protec- tion and heavy clothing.
•Hold trigger handle with right hand and assist handle with left hand.
•Hold unit so that engine is below waist level.
•Cut only from your left to your right to ensure debris is thrown away from
you. Without bending over, keep line near and parallel to the ground and not crowded into material being cut. Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full throttle. At lower speeds, there
is less engine noise and vibration. 12