TO RELOCATE SHOULDER STRAP
CLAMP:
1.Loosen and remove both clamp screws.
2.Place the upper shoulder strap clamp over the shaft.
3.Position the lower shoulder strap clamp under the shaft and align
the upper and lower clamp screw holes.
Upper Shoulder
Clamp
Lower | Shoulder | l |
Strap | Clamp | Screws |
|
|
4.Insert two screws into the screw holes.
5.Secure shoulder strap clamp by
tightening screws with a hex wrench.
HARNESS
ADJUSTMENT
FOR BALANCE
6 inches | 4 | |
below | ||
waist | inches | |
above | ||
| ||
30 inches | ground |
I
30i
CONFIGURING YOUR UNIT
You can configure your unit using a cut- ting head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch in diameter. To assemble your unit, go to the section for
the desired configuration and follow the instructions.
ASSEMBLY INFORMATION - TRIMMER HEAD
::_TRIMMER
NOTE: Remove the blade and metal shield before attaching the plastic shield and trimmer head. To remove blade, align hole in the dust cup with the hole in the side of the gearbox by rotating the dust cup. Insert a small screwdriv- er into aligned holes. This will keep the
shaft from turning while loosening the
blade nut. Remove blade nut by turning clockwise. Remove the screwdriver.
Remove both washers and blade. To remove metal shield, loosen and re-
move the four mounting screws. See ATTACHING THE METAL SHIELD and
INSTALLATIONOF THE METAL BLADE for
illustrations. Be sure to store all parts and instructions for future use.
INSTALLATION OF THE CUTTING
HEAD (if not already installed)
NOTE: Before installing the trimmer head, make sure the dust cup and re- taining washer are positioned on the shaft of the gearbox. The retaining washer must be positioned with the raised section toward the gearbox.
1.Align hole in the dust cup with the hole in the side of the gearbox by rotating the dust cup.
2.Insert a small screwdriver into aligned holes. This will keep the
shaft from turning while tightening trimmer head.
Screwier _
