• Neveruseforspreadingchemicals, fertilizers,oranyothersubstances whichmaycontaintoxicmaterials.
STANDARDS
This product is listed by Underwriters Laboratories, Inc., in accordance with UL Standard 1017.
If situations occur which are not covered
in this manual, use care and good judg- ment.
If you need assistance, contact your Sears Service Center or call
Failure to follow all Safety Rules and Precautions can result in serious injury.
SAVE THESE INSTRUCTIONS
CARTON CONTENTS
Model 358.799343
•Blower
•Blower Tube
•Nozzle
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find parts missing or damaged, call
_WARNING: | If received as- |
sembled, ensure your unit is properly assembled and all fasteners are secure.
ATTACHING THE BLOWER TUBE AND NOZZLE
1.Insert the blower tube into the blow- er outlet.
2.Twist the blower tube clockwise until it is firmly seated in the blower outlet.
3.Twist the nozzle into the end of the
blower tube until it is firmly seated. Make sure the nozzle end points upward as shown in the following illustration.
Blower Tube Nozzle
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as shown on nameplate of the unit to power your blower.
•To reduce the risk of electrical shock, this equipment has a polarized plug (one blade is wider than the other) and will require the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only
one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord.
A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If plug does not fit fully into the wall outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way.
The extension cord used to reach the power source must be:
•Specifically marked as suitable for out- door use. The cord must be marked
with the suffix
•Heavy enough to carry current from
the power source the full length of ex- tension cord to the unit. Otherwise,
loss of power and overheating can oc- cur causing damage to unit. Refer to
table for minimum wire gauge recom- mendations. The cord must be
marked with the proper wire gauge. (Appropriate extension cords are avail-
able at Sears.) Do not use multiple cords.
•In good condition. Cord insulation must be intact with no cracks or
deterioration. Plug connectors must be
undamaged. DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
50 FT 100 FT.
A.WG* A W.G.*
16 14
*American Wire Gauge
SECURE EXTENSION CORD TO UNIT
CAUTION: Failure to use cord retain-
er could result in damage to the unit, extension cord, or both.
5
