
ADJUSTING THE SHOULDER STRAP
ON THE COLLECTION BAG
1.Carefully loop tile shoulder strap
through the buckle as shown in the illustration below.
Last In _
2.Position the unit on your
side, blower outlet and bag pointing toward the rear. Hold the unit in an
upright position with the lower vacu- um tube on the ground to support it.
3.Place the shoulder strap over your head and onto your left shoulder.
4.Adjust the strap to allow a free flow of air from the blower. If the collec-
tion bag is kinked, the unit will not operate properly.
NOTE: The strap is designed to position the collection bag on your shoulder with- out kinks. The strap is not intended to support the weight of the unit.
Shoulder strap on left shoulder
No kinks in bag allows free air flow
HOW TO CONVERT UNIT FROM VACUUM USE TO BLOWER USE
1.Stop unit and unplug tile extension cord.
2.Remove the vacuum tubes and collection bag.
3.Install the inlet restrictor that was re-
moved when assembling for vacuum use.
NOTE: If you are unable to locate the inlet restrictor, the unit will still operate.
This restrictor improves the blower function.
4.Close the inlet cover and make sure it is latched closed.
5.
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as shown on nameplate of the unit to power your blower.
The extension cord used to reach the power source must be:
•Specifically marked as suitable for out- door use. The cord must be marked
with the suffix
•Heavy enough to carry current from the power source the full length of ex- tension cord to the unit. Otherwise, loss of power and overheating can oc- cur causing damage to unit. Refer to
table for minimum wire gauge recom- mendations. The cord must be
marked with the proper wire gauge. (Appropriate extension cords are avail- able.) Do not use multiple cords.
•In good condition. Cord insulation must be intact with no cracks or
deterioration. Plug connectors must
be undamaged. DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
A.WG*50 F_ | 100A W.G.FT.* |
16 | 14 |
*American Wire Gauge
SECURE EXTENSION CORD TO UNIT CAUTION: Failure to use cord retain-
er could result in damage to the unit, extension cord, or both.
1.Loop extension cord through cord retainer.
2.Insert cord receptacle through loop.
3.Hold the cord receptacle in one hand. Use the other hand to gently pull on the extension cord to remove slack. NOTE: Only remove enough slack from the extension cord to secure it to
the cord retainer. Pulling too hard could damage the extension cord.
4.Insert the cord receptacle into the recessed plug.