5.Connect BLACK grounding cable to negative
hex bolt and keps nut. Tighten | Hood | |
securely. | \ | |
6. Close battery box door. | ||
|
Battery
Door
Hsx
Nut
Positive (Red) Cable | Negative (Black) |
| Cable |
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiringmay cause your tractorto run poorly,stop running, or prevent it from starting.
•Chock wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in frontof tractor. Grasp hood at
sides, tilt toward engine and lift oft of tractor.
4.To replace, reverse above procedure.
W,re
ENGINE
Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any
TO ADJUST THRO'FFLECONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke position. Slowly move lever from choke to fast position.
2.Chock to see if hole in throttle lever
and hole in speed control bracket are aligned.
3.If holes are not aligned, loosen cable clamp screw and align the holes by inserting a pencil or a 1/4" drill bit through both holes.
4.Pull throttle cable up to remove slack and tighten cable clamp screw. Remove alignment pencil or drill bit.
Cable
Screw
Speed Control
Throffiel
25