ASSEMBLY
1.Spring Tines (7)
2.Frame Assembly
3.Gauge Wheel
4.Mount Brackets (2)
1
2
4
3
TOOLS REQUIRED FOR ASSEMBLY(1)7/16" Wrench
(2)1/2" Wrenches
(2)3/4" or Adjustable Wrenches
(1)Knife
REMOVAL OF PARTS FROM CARTON•Remove all parts and hardware packages from the carton. Lay out all parts and hardware and identify using the illustrations on pages 3 and 4.
•Turn the frame assembly as shown in figure 1.
•Assemble seven spring tines to the top of the frame tube. Use a 5/16" x
NOTE: On sweepers smaller than 42", use only five spring tines.
•Assemble a vinyl cap onto each end of the frame tube. See figure 1.
5/16" x
3/8" WASHER
5/16" NYLOCK NUT
VINYL CAP
FIGURE 1•Assemble a 1/2" washer, the wheel, another 1/2" washer and the 1/2" plain jam nut onto the 1/2" x
•Insert the bolt through the welded bracket and assemble the 1/2" nylock jam nut onto the bolt. Adjust the nuts so that there is no end play in the wheel and then tighten the nuts securely against the welded bracket. Make sure the wheel still turns freely. See figure 2.
Use this hole for 42" & 46" sweepers
Use this hole for smaller sweepers
1/2" NYLOCK
JAM NUT
1/2" JAM NUT 1/2" WASHER
1/2" WASHER
1/2" x
HEX BOLT
FIGURE 2
4 | Call |
| DO NOT RETURN TO STORE |