STEP 3: (SEE FIGURE 3)
•Insert the ends of the base leg tubes into the upper base tube.
UPPER BASE TUBE
BASE TUBE LEGS
FIGURE 3
STEP 4: (SEE FIGURE 4)
•Raise the tractor seat and remove the seat springs and the four bolts from the rear fender using a 1/2" socket.
•Place the base leg tubes onto the rear fender. Attach the front support brackets to the front holes in the fender reusing the bolts that were removed. If seat springs were mounted to front holes, see note below.
Do not tighten completely.
•Attach the base bracket and the seat springs to the rear holes in the fender using the new 5/16" x 1" bolts
(E)and 5/16" fl at washers (H) supplied with the Snow Cab. If seat springs were mounted to front holes, see note below. Do not tighten completely.
•Tighten the nuts and bolts that fasten the base leg tubes to the base bracket and front support brackets.
•Center the base leg tubes on the rear fender and then tighten, using moderate force, the bolts fastening the base bracket and the front support brackets to the fender. Overtightening the bolts may damage the threaded holes in the fender.
•PROCEED TO STEP 8 ON PAGE 7
NOTE: If seat springs were mounted to front holes, use 5/16" x 1" bolts (E) and 5/16" fl at washers (H) to attach seat springs and front support brackets to front holes.
Use original bolts to attach base bracket to rear holes.
ORIGINAL | 5/16" x 1" | |
HEX BOLT (E) | ||
BOLT | ||
5/16" WASHER (H) | ||
| ||
| SPRING | |
| (SEE NOTE) |
FIGURE 4
INSTRUCTIONS FOR TRACTORS WITH DUAL SUSPENSION BRACKETS
STEP 5: (SEE FIGURE 5)
•Attach the right base bracket to the front holes of a base leg tube that does not have a fl attened end, using two 5/16" x
5/16" NYLOCK NUT (G)
SPACER (J)
5/16" x
CARRIAGE BOLT (A)
LEFT BASE
BRACKET
BASE LEG TUBE
RIGHT BASE BRACKET
FIGURE 5
STEP 6: (SEE FIGURE 6)
•Insert the ends of the base leg tubes into the upper base tube.
UPPER BASE TUBE
BASE LEG TUBES
FIGURE 6
6