•Assemble the wheel support to the bottom of the cart using eight 5/16" x 3/4" truss head screws, 5/16" lock washers, and 5/16 hex nuts as shown in figure 4.
Heads of screws go on the inside of cart. Tighten.
TRUSS HEAD SCREW
5/16" x 3/4"
| "5/16" LOCK |
| WASHER |
WHEEL |
|
SUPPORT | _16"HEX NUT |
FIGURE 4
•Lower the cart to rest upside down, with the wheel support facing up, as shown in figure 5.
NOTE: The parts assembled in the next paragraph are shipped in the Vac carton.
Assemble the skid plate to the bottom of the cart using two 1/4" x 1" hex bolts, four
SKID PLATE
1/4" HEX NUT
114"LOCK
WASHER
FLAT WASHER
1/4" x 1"
HEX BOLT
FIGURE 5
Align the latch stand bracket so that the tab is at the rear. Fasten the bracket to the rear set of holes at the front of the cart using two 1/4" x 5/8" hex bolts, 1/4" flat washers, 1/4" lock washers, and 1/4" hex nuts. Use the 1/4" flat washers as shims between the bracket and the cart bed. Make finger tight at this time. See figure 6.
LATCH STAND 1_" HEX NUT
(Tabatrear)I_"LOCK
BRACKET _/
WASHER
I_"FLAT
\
1/4" x 5/8"
HEX BOLT
FIGURE 6
Place the rear tongue onto the wheel support and the latch stand bracket. Assemble the axle through the ends of the wheel support and the tongue. Fasten the axle to the wheel support using two 1/4" x
IMPORTANT: Make sure the tongue is securely locked to the latch stand bracket by the latch lock lever.
1/4" x
HEX BOLT
_ AXLETONGUE
/'2
_" 1/4" LOCK WASHER
"_ 1/4" HEX NUT
FIGURE 7
10
